Recently, a customer inquired about the high-voltage cable of the x-ray machine. The high-voltage cable of the x-ray machine produced by newheek is 3-core. The 3-cores correspond to a large focus, a small focus, and a common end. The following is a detailed explanation of the high-voltage cable cores of the x-ray machine ”
The bottom of the socket of the X-ray high-voltage cable is cast with 3 copper terminals. A hole with a depth of 1cm is drilled in the middle of the terminal to make the plug and socket of the X-ray high voltage cable fit well. The front end of the plug of the X-ray high-voltage cable is equipped with 3 copper pins connected to the socket, and the pins are equipped with wiring holes for welding the core wires of the cable. The inner end of the plug is inlaid with a copper bell mouth for welding with the metal shielding layer of the X-ray high-voltage cable to form a good grounding. X-ray high-voltage cable plug: its pin is die-casted on the side of the head end of the high-voltage plug, and the root part of the pin is provided with a small lead hole for passing the conductive core wire and welding the conductive core wire to the root of the pin In order to match the high-voltage plug, the bottom of the socket of the X-ray high-voltage cable will be provided with three copper terminals matching the high-voltage plug, and each terminal will be provided with a round hole for the pin insertion of the high-voltage plug. In order to improve its insulation strength, the gap between the X-ray high-voltage cable and the high-voltage plug must be filled with high-voltage oil. The bottom of the high-voltage plug is also provided with a metal bell mouth, the purpose of which is to improve the electric field distribution of the grounding deduction and prevent the wiring between it and the ground from being too dense.
See here, everyone fully understands, if you have any needs, please call us.