Use of high-voltage cables for x-ray machines - Newheek X ray Cable

Use of high-voltage cables for x-ray machines

A Czech customer asked about high-voltage cables for X-ray machines. In this article, I would like to introduce to you the 75KV and 90KV high voltage cables produced by Newheek.
The high-voltage cable connects the high-voltage generator of the large and medium-sized x-ray machine and the x-ray tube assembly.
The 75KV x-ray machine high-voltage cable is mainly used to connect the 125KV tube voltage tube to the high-voltage generator, and the 90KV high-voltage cable is mainly used to connect the tube voltage 150KV to the tube connecting tube and the high-voltage generator.
X-ray machine high-voltage cables have two connection modes: straight pipe and elbow pipe, and any length can be customized. The conductor of the high-voltage cable of the x-ray machine is tin-plated copper, which is not easy to oxidize, and the nominal cross-section is 1.8mm.
The configuration of the connector is a three-hole plug. Pay attention to the corresponding positions of the three holes when installing. The three holes are labeled C (common endpoint), S (small focus) and L (large focus). The C hole is on the top, the S hole is on the left, and the L hole is on the right. If the hole is not installed correctly, it will affect the normal use of the cable. Always pay attention to keeping the cable dry and clean, avoid oil, moisture and harmful gas corrosion, and avoid rubber aging.

high-voltage-table